D1414 Installation
Instructions:
- Connect lamp housing and power pack
- Plug the three prong plug from power pack
into the 115 Vac outlet. This controls the heater only. The two
prong cord to be plugged into dimmer when
this component is used. If the dimmer is not used, the two prong
cord can be plugged directly into the timer.
- When dimmer is used plug three prong cord
from dimmer into dimmer
Turn on switch labeled thermo Control. This pre
warms the unit and maintains the optimum operating temperature around
the lamp continuously insuring instant peak intensity at each timed
cycle.
Allow unit to warm up
approx. 15 minutes prior to making any exposures. To speed up the
warm-up process, the lamps may be turned on for approximately 2 minutes.
Caution:
Do not leave lamps on
continuously for more than 5 minutes as unit is designed for
intermittent operation only in photographic exposure
Caution:
Instructions are for guidance only.
Aristo/Voltarc will not be responsible for any damage to lamp
or lamp housing for items improperly installed. |
