Installation:

• At the electrode-cut the silicone between
  lamp reflector housing (metal) and glass
  electrode by a sharp knife or blade.

• Cut the copper tie wire.

• Carefully pull the lamp out from the clip.
  (Pull from position closer to the clip)

• Position the new lamp over the clip. Push the lamp in the Clip.
  (By putting slight pressure at clip point only)

• Connect one transformer black wire to one lamp wire.
  Repeat the same with the second black wire of the transformer to the other lamp wire.
  (Use the wire nuts you have removed in step 3.0

• Put the cover back in position.

• Put the sheet metal screws back.

• Tire wire and Silicone is not necessary as they are put in for the safety of the lamp during shipping.