Unscrew the nut for the grounding wires using 1/2
drill bit
PIC 3
PIC 4
Using the hole from the grounding
screw- enlarge this hole to a 1/2" diameter. To
re-attach the grounding wires, drill a new hole to
the upper right approx. 1/4" dia, as in picture.
PIC 5
PIC 6
Cable from new dimmer switch as 3
wires:
Green = Ground;
Black = Line
White = Neutral
Place these three
wires from the dimmer switch into the 1/2" hole and
enclose with the plastic bushing. Compress bushing
with pliers until secure in the 1/2" hole
PIC 7
PIC 8
Looking from
inside the unit, re- attach the grounding wires to
the grounding screw (Phillips screw)
Install a crimp connector on black (Line) wire on
the cable.
PIC 9
PIC 10
Front: Color
Switch
From back of the
color switch, remove white wire from terminal on
color switch
PIC 11
PIC 12
Place black (Line) wire from newly installed dimmer
cable on the color switch terminal
Cut
connecter/lug off of the white (neutral) wire.
Strip wire and
twist together with white wire from the new dimmer.
Apply wire nut.
Plug
green dimmer into the new connection.
Plug
in power cords.
Turn
on and adjust color switch to green light.
Turn
on dimmer, adjust dimmer knob- green lamp should
adjust with dimmer.
Turn
off power pack and put back cover back on unit
Caution: Instructions are for guidance only.
Aristo/Voltarc will not be responsible for any damage to lamp
or lamp housing for items improperly installed.
